The complete set for the building of a 4-meter greenhouse 3 sheets of cellular polycarbonate in the form of rolls of 2.1 m length and a diameter of 60-90 cm. The thickness of the substance is 4 mm.

If you would like, you can raise the length of the structure to 6 yards or longer. To try it, it is enough to join a two-meter expansion. When selecting a drawing, then pay attention to the distance between the arches. This figure must be 65 cm, and which is the most appropriate duration for the specified depth of the substance. The diameter of the doors based on the maker’s drawing is 90 cm.

Before building a polycarbonate greenhouse, it’s important to select a place because of its place. If that is done properly, it is possible to provide yourself with a crop of fresh vegetables for the entire calendar year.

The location for the future greenhouse is marked instantly in the planning of their garden plot. So as to melt the snow in the place of the greenhouse as early as possible, the very best point on the site is going to be a slight elevation. Moreover, in such a location won’t have to be worried about higher humidity as dirt and air in the construction.

Assemble a polycarbonate greenhouse on a raised site – intends to look after the optimal temperatures indoors.

If it isn’t feasible to place a greenhouse in an elevated position, you’ll need to pour a layer of fine crushed stone around 20 cm and the same layer of fertile land to make seedbeds.

Before assembling a greenhouse in your backyard plot, it’s also wise to consider where and how this construction is going to be set up. First, you have to select a place for it. The greenhouse ought to be located in a well-lit area no less than a few meters away from houses, barns and other structures.

How to install a greenhouse Based on the Faces of the Planet

Be sure to measure the dirt surface – it’s ideal to remove the top layer. This will also get rid of weed seeds. And for simplicity of work, eliminate the dirt in an area that is going to a meter wider on all sides of the rectangle you desire.

It’s also worth thinking about using a foundation. As manufacturers say, now most greenhouses do not need that, particularly if they (greenhouses) are used only in the spring and summer period. But, experienced gardeners still recommend earning an elementary basis from a pub. It’s very simple – it is sufficient to associate with each other utilizing metal corners and screws four parts of wood with a cross-section of 10 * 10 cm. The size of such a base ought to be equivalent to the base of their upcoming greenhouse.

Simple bar foundation

You can also produce a strip base of concrete. He is more reliable than a pub base, but demands greater fiscal and labor expenses. Incidentally, the rainwater, which will be utilised in winter, with no and don’t do with it at all.

Stages of the creation of a strip base: a schematic representation

Many producers counsel to set up greenhouse structures without building a foundation. For this use, they equip the framework with special T-shaped legs, so that the construction was securely fixed. However, as practice shows, it is still crucial to build a foundation: so and the basis will be more rigorously fixed and also the components of the foundation that are in touch with the soil, will be stored much more gidpostroy.ru in its original state.

The principal issue is to deal with the material with specific agents to protect the wood from moisture. The substance is normally installed on concrete blocks that are dug into the soil. To get a six-meter structure, they want 10 bits: four to each side and one in the center of the ends.

Before you do the greenhouse itself, you want to pick the perfect spot for it. It has to be an even site, so the frame was located equally, without distortions. It needs to be sunny and never obscured by buildings or trees.